HS 815BB MEGA SAIL ARM CONTROL 31815S

This is in extremely powerful sail winch servo, with dual ball bearings and
                            Hitec S type connector.
    Connector is compatible with all modern receivers and wiring accessorie

SPECS: Indirect drive motor
       Water tight case
       Transit time  .46 seconds/140°
       Torque  231 oz-in

DIMENSIONS: 66x30x56.7mm, 2.59x1.18x2.23" (L,W,H)

INCLUDES: Servo mounting screws, grommets, and eyelets
          1 each of the following servo arms. Large wheel, large X, and large
          straight arm.
          1 sail arm, 122mm overall length, 110mm center of mount to outside
          hole.
          Special Y- harness for use with BEC receivers (see comments)

COMMENTS: This servo consumes 800mAh UNLOADED, Hitec states that it REQUIRES
          a minimum of 1200mA receiver battery, 6V (5 cell) is STRONGLY
          recommended.
          If connecting to a BEC receiver, the Rx battery must be plugged in
          to one side of the supplied Y harness, the servo into the other
          side, and then connected to the receiver. IT WILL NOT WORK IF RUN
          WITH A BEC RX CONNECTED IN ANY OTHER WAY!!!!!
          Standard Rx's connect as normal

          For replacement Gear Set, order HRCM6350.