DTXC2542 4-SHOE CLUTCH KIT .21

This Clutch Shoe Kit for .21 OS Max Engines gives More Surface Area Than a Two Shoe Design, Which Gives You Better Clutch Bell Grip and Improved Acceleration.

INCLUDES:

• One Aluminum 4-Pin Flywheel (solid, not drilled out for lightness)
• One Clutch Nut (holds flywheel onto crankshaft)
• One Washer with Holes for Flywheel Pins (10x24mm)
• Four Black Clutch Shoes
• Four Clutch Springs
• One Wide Aluminum Spacer (6.5mm thick)
• One Narrow Aluminum Spacer (4.5mm thick)
• One 5.5x9.5mm thick Shim/Washer
• Three 5x8mm thin Shim/Washer
• One 3x5mm Cap Screw
• One 3.5x8mm Washer
• One Instruction

REQUIRES: Bearings for the Clutch Bell are DTXC1535.
Clutch Bells DTXC2521 DTXC2526.

COMMENTS:

• The replacement shoes for this kit are DTXC2545.
• Will NOT work on the Inferno MP-5.
• WILL NOT WORK ON ENGINES WITH A PILOT SHAFT
• This kit may be used on the TORQ 21. You need to use the Drive washer for the TORQ 21 DTXG0565 instead of the spacer.
• The current clutch kit has a revised clutch nut that eliminates the large e-clip. The e-clip is no longer included in the package, and this change has no effect on the attachment or operation of the clutch kit.