O que você está buscando?





CRAZEDPILOT LED COCKPIT LIGHTING RED CLS-RED

  • Código: 372916
  • Estoque: Disponível
  • $49,95

Compartilhar

Não fazemos entregas fora do paraguai
Preços informados são em Dólares americanos, não incluem IVA e podem variar sem prévio aviso.


      PRODUCT DESCRIPTION
      The simplest and best priced LED cockpit lighting and interior lighting system on the market - the CRAZEDpilot LED Cockpit Lighting System NOW INCLUDES 15 feet of adhesive-backed flexible LED light strip (AVAILABLE IN PURE WHITE, RED, AND BLUE!)  Can be trimmed to any length (or multiple lengths, read on!)  The system also contains a digital dimmer control with black panel-mount knob, and detailed installation instructions and clear wiring diagram.

      Weighs ONLY 2.5 ounces installed!

      The digital dimmer control uses pulse technology to prevent heat generation and current draw commonly found in inferior designs.   Less than 1 amp current draw at full brightness!  This light system does not generate bulb heat - you will never get burned or melt anything! 

      WATCH THIS VIDEO REVIEWING THE PRODUCT:


      WE SHIP WORLDWIDE! Add to cart to get a price! It's usually about $12!

      This interior lighting system is very easy to install - trim the light strips to the desired length at 2 inch intervals, wire as shown in the instructions, and light will not only glow softly on your instrument panel but can be turned up bright enough to illuminate clear to the flap controls or the floorboards to find that chart you dropped!  Some customers even cut their Cockpit Lighting Systems into multiple small segments, and run wires to each, giving single-knob control over lights placed all over the inside of the aircraft!

      One CRAZEDpilot dimmer controller can control up to 25 feet of light strip. The LED light strips are 8mm wide by 3mm thick made using flexible PC-board technology - with a clear vinyl coating over a black background, these light strips nearly disappear when not illuminated.  The strips are capable of curves and contours of a 2 inch radius, which will fit nicely into the corner of your glare shield or custom panel (see photographs on this page).  The 3M adhesive backed light strips bond and stay bonded once placed permanently. The controller is driven from your 12V DC battery.

      NOTE: For experimental aircraft only.  

      LIABILITY RELEASE/DISCLAIMER:
      These lights are intended to be a low-cost alternative to bring additional lighting into your interior. Do not rely on these as your sole source of light after civil twilight as they do not meet the entire requirements of FAR 91.205 for night time operations on their own.  By installing these lights you are agreeing to release all liability against CRAZEDpilot, its staff and representatives, for the use or mounting of these lights and its effect on your flight or its effects on the flight characteristics of your aircraft after installation. Not for use on certificated aircraft.

      This product to be used for lighting controls only.  As the pilot in command you are accepting all responsibility for the safety of your aircraft, those onboard, and persons or property on the ground.  CRAZEDpilot makes no representations of warranties, either expressed or implied, by or concerning any content of these written materials and in no event shall be liable for any implied warranty for any consequential, incidental or indirect damages (including but not limited to damages for loss of business profits or business interruption) arising from the use or inability to use these written materials or equipment.

Escreva um comentário

Você deve acessar ou cadastrar-se para comentar.