This mount allows you to easily attach a Survey3, Survey2 or Survey1 camera securely to a DJI Mavic drone while keeping the original drone camera installed (and unobstructed). Its simple four screw installation makes it easy to remove and transport.

Recommended flight speed for survey is 20 mph or slower.

Included:

(1) Durable & lightweight plastic mounting plate

(4) Dampening balls

(1) Single Survey camera mounting plate

(4) M2 screws (replaces existing DJI screws)

Weight (Camera+GPS+Mount): 173g

Peau Productions (MAPIR) is in no way liable for any damage caused to or by your drone. We have thoroughly tested this mount and when installed properly will not interfere with the normal operation of the drone. The sport speed settings of the DJI Mavic are not recommended when mount is in use.

Install Instructions:

Step 1: The mount will already come assembled. Simply unscrew the original DJI screws in the 4 locations marked below with a (not included) 1.5mm hex tool:

Step 2: Place the mount as shown and tighten the four screws included with the mount. The screw holes have pegs that will snap into place:

Step 3: If you are installing a Survey3 camera, feed the GPS receiver cable through a hole in the mount, plug the USB cable into the side of the camera and peel off the adhesive backing on the bottom of the GPS receiver. Make sure to press it down securely such that the GPS receiver adheres to the center of the mount, as shown: