This mount allows you to easily attach up to two Survey3, Survey2 or Survey1 cameras to the Phantom 4 and Phantom 4 Pro drones while still keeping the original drone camera installed.

Camera clips are required and must be purchased separately if you don't already have them.

Peau Productions (MAPIR) is in no way liable for any damage caused to or by your drone. We have thoroughly tested this mount and when installed properly will not interfere with the normal operation of the drone.

Included:

(1) Durable & lightweight plastic mounting plate

(4) M2 Screws (replace existing DJI screws)

(4) Dampening balls

(1) Dual Survey camera mounting plate

Dual Camera Mount Weight (not including camera clips and cameras): 40.15g

Install Instructions:

Step 1: The mount will already come assembled. Simply unscrew the original DJI screws in the 4 locations marked below with a (not included) 1.5mm hex tool:

Step 2: Place the mount as shown and tighten the 4 screws included with the mount:

Step 3: If using the Survey3 cameras, feed the GPS receiver cable through a hole in the mount, peel off the adhesive backing on the bottom of the GPS receiver, and press it such that the GPS receiver adheres to the center of the mount. Try not to have the adhesive touch the dampening balls for the best adhesion.