MAPIR PHANTOM 4 SINGLE MOUNT SURVEY 2/3

This mount allows you to easily attach a Survey3, Survey2 or Survey1 cameras to the Phantom 4 or Phantom 4 Pro drones while still keeping the original drone camera installed.

Camera clips are required and must be purchased separately if you don't already have them.

Peau Productions (MAPIR) is in no way liable for any damage caused to or by your drone. We have thoroughly tested this mount and when installed properly will not interfere with the normal operation of the drone.

Included:

(1) Durable & lightweight durable plastic mounting plate

(4) M2 screws (replace existing DJI screws)

(4) Dampening balls

(1) Single Survey camera mounting plate

Dual Camera Mount Weight (not including camera clips and cameras): 32.82g

Install Instructions:

Step 1: The mount will already come assembled. Simply unscrew the original DJI screws in the 4 locations marked below with a (not included) 1.5mm hex tool:

Step 2: Place the mount as shown and tighten the 4 screws included with the mount:

Step 3: If using the Survey3 cameras, feed the GPS receiver cable through a hole in the mount, peel off the adhesive backing on the bottom of the GPS receiver, and press it such that the GPS receiver adheres to the center of the mount. Try not to have the adhesive touch the dampening balls for the best adhesion.