CARRO HB TESSMANN 1/8 KIT D8T 113391

FEATURES

• Chassis: 0.16" (4mm) thick 7075 aluminum with 10° of kickup, composite chassis braces
• Drive: Four wheel shaft drive, lightweight aluminum axles
• Engine Mount: One-piece CNC aluminum
• Fuel Tank: 5.1oz (150cc) plastic with flip top cap
• Air Filter: Foam low profile design
• Clutch: 3 shoe, plastic construction
• Clutch Bell: 13 tooth steel
• Transmission: Single speed
• Ball Bearings: Full set
• Hubs: CNC aluminum with hinge pin inserts, aluminum front hub carriers and caster blocks
• Shocks: Oil-filled, 16mm Big Bore aluminum bodied
• Shock Towers: Carbon fiber
• Main Gear: 50 tooth lightweight
• Gearboxes: Sealed
• Differentials: Planetary
• Brakes: Dual fiber discs
• Body: Clear ProLine Bulldog cab-forward racing body, with Upgrade R/C Vortex Wing
• Bumpers: Front hardened plastic
• Suspension: Captured hinge pin design, extra wide pivot block for optimized geometry, front and rear sway bars, lightweight aluminum pivot balls, wide stance solid arms
• Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis
• Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle
• Ackermann: Adjustable, Ackermann refers to the effect of the inner front wheel turning faster than the outer front wheel during turns
• Steering: Bell crank type with servo saver, CNC machined billet aluminum steering blocks, servo saver dust boot
  
  

INCLUDES

1/8 scale Hot Bodies off-road Truggy Kit, foam air filter, body, rear wing, clutch bell, spur gear, instructions, decal sheet, diff and shock oil

REQUIREMENTS

• Radio: 2-Channel with 2 Servos (one high torque servo for steering)
• Radio Batteries: (8) AA size
• Receiver Pack: 6V hump
• Engine: .21-.28 cu in (3.4-4.6cc) rear exhaust
• Exhaust: Tuned pipe
• Engine Starter: Hand-held type with rubber adapter for vehicle use
• Wheels: 1/8 scale off-road truggy
• Tires: 1/8 scale off-road truggy
• Glow Starter: 1.2 volt
• Paint: Polycarbonate safe for body
• Misc. Items: Fuel bottle, building and track equipment
• Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant- Most of the fuels we carry meet or exceed the lubricant content required for optimum performance and maximum engine life. In the past, the conventional lubricant content used in fuel was 18%. But with new advanced technologies, fuels like Red Alert and O'Donnell for example, have a better quality of lubricants even though the percentages of lubricant content are lower. These high-tech lubricants provide exceptional cooling and protection.

SPECIFICATIONS

Vehicle-

• Length: 21" (530mm) from front bumper to end of rear wing
• Width: 15.9" (405mm)
• Weight: 9lbs (4082g) approximately
• Wheelbase: 15-15.1" (380.5-383.5mm) wheels on-center front-to-rear
• Gear Ratio: 4.3:1

Body-

• Length: 18.2" (462mm)
• Width: 7.4" (188mm) at middle section (widest point) 6.9" (175mm) ahead of front wheels (thinnest point)
• Height: 4.1" (105mm)