CARBURADOR GMS .61 GMS 613100

This is the GMS Carburetor Assembly/Remote Needle set for the .61 engine

FEATURES:

• Set screw at the end of needle valve to mount a scratch-built needle valve adjusting rod.
• Low Speed adjustment via mixture control centered in throttle arm.
• Steel throttle arm and needle valve mount.
• Aluminum construction.

INCLUDES:

• One remote needle valve with mounting bracket.
• One small section of clear fuel tubing.
• One assembled carb.

SPECS:   

• Length: 24mm (0.95")
• Width: 66mm (2.63")
• Height: 38mm (1.49")
• Diameter of carburetor base: 15mm (.59")
• Diameter of carburetor intake: 15mm (.59")

COMMENTS:

• If Carb Retainer Nut is needed, use  A .062" wire (not included) can be used to extend the needle valve by inserting the wire into the pre-drilled hole on the end of needle valve and tightening it in place with the supplied set screw.