CARRO MUGEN 1/8 MBX6T TRUGGY KIT E0065

This is the glow powered, radio controlled, 1/8 scale Mugen MBX6T M-Spec Off Road Prebuilt Truggy Kit.

FEATURES:

• Chassis: A7075 T6 aluminum 0.12" (3mm) thick, gun metal gray in color
• Drive: Four wheel three differential shaft drive
• Shocks: Four oil filled aluminum body
• Shock Towers: 0.16" (4mm) thick carbon graphite
• Gearbox: Sealed, front and rear
• Differentials: Planetary geared
• Fuel Tank: 4oz (120cc) approximate
• Transmission: Single-speed
• Ball Bearings: Full set
• Suspension: Pillow ball
• Body: Clear truggy type with molded white rear wing
• Clutch: 3-shoe aluminum
• Clutch Bell: 13 tooth steel
• Spur Gear: 46 tooth
• Camber Tie Rods: Adjustable, Camber describes the angle at which the tires sit vertically
• Steering Tie Rods: Adjustable, Caster/Toe-in is the angle at which the tires point inward as viewed from above
• Steering: Bell-crank type, with carbon graphite steering brace and adjustable Ackerman.
• Ackerman describes the effect of the inside front wheel turning faster than the outside front wheel during turn

INCLUDES:

Mugen MBX6 M-Spec Off Road Truggy Kit with clear truggy body, white plastic rear wing, decal sheet, window mask sheet, air filter, illustrated instruction manual

REQUIRES:

• Engine: .21 cu in rear exhaust
• Exhaust: Tuned pipe with manifold
• Radio: 2-channel with standard servo for throttle and high torque servo for steering
• Starter Box: For 1/8 scale truggy use
• Tires and Wheels: 1/8 scale truggy
• Building and track equipment

SPECS:

Vehicle

• Length: 22.2" (565mm)
• Width: 17.04" (433mm)
• Wheelbase: 14.7 - 14.9" (373 - 378mm)
• Gear Ratio: 16.28:1
• Weight: 8.8lb (4,000g)

Body-

• Length: 19.3" (490mm)
• Width: 8.03" (204mm)
• Height: 4.3" (109mm)